The manufacturers and distributors of the equipment used in the FSM courses are completely separate from FSM and are not involved in Frequency Specific Seminars or in the teaching of uses of frequencies. The frequencies have to be delivered by some sort of electromagnetic device that supplies current. These devices are categorized as TENS devices and as such are only approved for and used in the treatment of pain. Most of the applications of frequencies are for pain which is consistent with the approved use of the devices. But the effects of biological resonance and frequencies have nothing to do with the devices or their approved uses.
Microcurrent is approved in the category of TENS devices by the FDA. TENS devices deliver milliamp current and block pain messages that are tying to get up the spine to the brain. Microcurrent delivers subsensory microamperage current, 1000 times less than milli-amperage current, which has been shown in published studies to increase ATP production in tissues.
So the question comes up, what are the difference between FSM frequencies and rife frequencies?
A lot of people have heard about Royal Raymond rife who used frequencies to treat cancer in the early 1900s. I think it was in the 1930s or so. He used a light microscope and his frequencies were light frequencies and they were between 8000 and 16,000 Hertz. He could tune the light on this microscope and watch it. When he got to a certain light frequency, it would literally cause this bacteria, or cancer cell, or virus to just blow up.
So his frequencies are all in the light frequency range. 8000 to 16,000 Hertz. He had hundreds of cancer terminal cancer patients that he had cured with his frequency therapy using these light frequencies. And unfortunately for us, the FDA and the American Medical Association decided they needed to shut him down. They raided his lab one morning, destroyed his equipment, confiscated all his records, and that was the end of that.
The rife devices that are out on the markets. Some of them actually have had access to his list of frequencies. But those frequencies are all between about 8,000 and 16,000 hertz because they were light frequencies when those frequencies are talked about as electrical pulses Rife didn’t use them that way. He used them as light frequencies. So the basic difference between rife and FSM is his frequencies or higher. All of the FSM frequencies are below a thousand hertz. I think 988 is the highest frequency we use. And then they run the whole range, one hertz, three hertz, two Hertz, clear up to 970 hertz to 988 hertz. And we use two channels. So when you use two channels, you have a frequency on channel A and a frequency on channel B and in the treatment area where those two frequencies cross the frequencies mix.
And so you have the frequency from Channel A and the frequency from B, you have the sum of the two frequencies, and you have the difference between the two frequencies. And quite honestly, we don’t know which part of that field has the therapeutic effect. So theoretically some of those frequency combinations; so if you’re treating 970 hertz on channel A and 783 hertz on channel B, we can get a combination beat frequency in the middle that above a thousand hertz. But the frequency’s themselves are all below a thousand hertz.
The other big difference is that we don’t treat cancer with frequency specific microcurrent for a number of reasons. Number one is that I don’t want to have happen to me what happened to Rife. That’s probably the first thing. But the second thing is that cancer serious. If I use a frequency and correctly and I make your pain worse, it’s just pain. But if we do something inadvertently through ignorance that accidentally make your cancer worse, I don’t have a way to help you get on top of it. So we don’t treat cancer. We can treat the side effects of cancer therapy. There are frequencies that take away the nausea from chemotherapy. We can treat, radiation burns from patients that are getting radiation therapy, and we treat very effectively the scar tissue from radiation therapy. So that’s the biggest difference between FSM and rife is just the range of the frequencies and what we treat with them.
In 1982 Ngok Cheng published, “The Effect of Electric Currents on ATP Generation, Protein Synthesis and Membrane Transport in Rat Skin in Clinical Orthopedics” (volume 171: pages 264-272). This study showed that microcurrent increased ATP production in rat skin by 500%. ATP is the chemical that the body uses for energy. The current also increased amino acid transport into the cell by 70% and waste product removal. The implications for human healing and repair are obvious. ATP production was increased as long as the current was below 500 microamps. When the authors increased the current to 1000 micro amps, or one milliamp, a current range delivered by TENS devices and other types of electrical stimulation therapies, the ATP production was actually reduced.
Our goal is to treat every patient in pain who wants to be helped by training practitioners who can treat them. And to teach, research, publish and promote FSM in such a way that it survives and thrives.
“Frequency Specific Microcurrent
Changing medicine one patient at a time
Changing patients’ lives one doctor at a time”
There can be no claims made for the diagnosis or treatment of any medical condition using frequencies. Science is a method of study not a body of information or a viewpoint. In any scientific endeavor an objective trained observer can make observations of effects. All science starts with observation of a phenomenon and then asks whether the phenomena can be measured and whether it is reproducible and predictable. The scientific method finally sets out to measure and observe the phenomena in a controlled fashion eliminating every other possibility for the observed effect besides the hypothesized mechanism being studied. FSM is in the early stages of this process. The phenomena are physical changes in biological tissue observed to occur only in response to certain specific frequency combinations applied with a microcurrent device delivering square wave pulses on two channels simultaneously. There are certain frequencies that produce effects that can be objectively measured, that are reproducible by any trained practitioner treating the same condition in a hydrated patient and that are predictable. Controlled trials are planned to finally confirm the frequency specific response.
During the practicum portions of the FSM Core seminar, there is generally at least one instructor for every 8-10 students. The Core seminar is available on DVD and practitioners can learn how to use FSM by reading the Frequency Specific Microcurrent in Pain Management text book. DVD learners can make arrangements with a trained FSM practicum instructor to be trained in the manual techniques and protocols for FSM in physical medicine in a private or small setting tutorial.
The machines, approved as TENS devices, can only provide symptomatic relief of pain. The current can increase ATP production as shown in the peer reviewed article published by Ngok Cheng in 1982.
Micro current is current in millionths of an ampere. An ampere is a measure of the movement of electrons past a point. Microamperage current is the same kind of current your body produces on its own within each cell. This is current in millionths of an amp. It is very small; there is not enough current to stimulate sensory nerves so the current flow cannot be felt. You can tell it is running by watching the conductance meter on the machine.
Ultra sound creates ultrasonic vibrations and creates heat by vibrating the water molecules in the tissue. It does not provide current nor does it change ATP status. It provides beneficial results by these mechanisms but it is just completely different than microcurrent.
Microcurrent provides electrons and in published studies increases ATP production in cells. Lasers provide photons. I am not aware of any research suggesting that laser treatment increases ATP production. Lasers oscillate at set frequencies and provide beneficial results but usually only provide one frequency at a time instead of the dual frequencies used in FSM treatment. Lasers provide whatever benefits they provide by some other method than frequency specific resonance and ATP enhancement.
Anyone who has enough medical background to understand and benefit from the course can attend. In order to practice FSM and purchase and use the equipment, they must have a license that allows them to use electrical stimulation or does not restrict them from using electrical stimulation on patients or must work for someone who has such a license. The course is geared toward medical, chiropractic, osteopathic and naturopathic physicians, acupuncturists and physical therapists and the assistants who function in all of these clinical settings.