Frequencies are pulses per second measured in hertz. They can be sound waves or electronic pulses. The frequencies used in FSM are electromagnetic pulses used on two channels firing at the same time. The frequencies are delivered using a ramped square wave that includes high frequency harmonics to create the square wave. The makes the frequencies more accurately pulses rather than the pure frequencies achieved with a sine wave generator. Most microcurrent devices use square wave pulses because they have been observed to be more effective clinically.
The frequency thought to address or neutralize the condition is put on channel A. The frequency thought to address the tissue is put on channel B. The frequencies used in FSM are all less than 1000 Hz. There are frequencies from the list alleged to address over 200 conditions from very common conditions like “inflammation”, “scar tissue”, “mineral deposits” and “toxicity” to very unusual and hard to document conditions like “polio virus”, “trauma” and congestion. There can be no claims made for the effects of the frequencies until research has documented their effects. All that can be said is that use of this or that frequency had this observed effect in this patient with a certain condition.
There are a few frequencies that are used as A/B pairs. A is not a condition, B is not a tissue but the combination of the two frequencies appears to have a therapeutic effect. There is one such frequency combination that takes away shingles pain. When this combination is used before the blisters break out for an hour a day for three days the pain is gone in 20 minutes and the blisters never break out. When this combination is used for two hours on active shingles, after the blisters appear, it eliminates the pain and shortens the course from the normal 6 weeks to four to five days. The pain never returns. Shingles is the only thing this frequency combination is good for and, so far, there has not been a patient who did not respond in an expected way.
Dr. McMakin didn’t develop the frequencies. The frequencies were developed between 1910 and 1934 by medical and osteopathic physicians using an entirely different machine and system of treatment. The frequencies are used clinically; the effects are documented in chart notes and serve as a basis for the development of protocols that appear to be effective for different clinical conditions. The protocols are taught during FSM seminars and then it is determined if the effects are reproducible based on feedback from practitioners. There are four peer-reviewed published papers documenting the effects in the treatment of myofascial pain from trigger points, neuropathic pain from fibromyalgia associated with spine trauma and delayed onset muscle soreness.
Category: FSM FAQs